Software Information, Self Test, Protocol

OPERATING INSTRUCTIONS FOR GAMBIT EQUALIZER EQ1-DYN	OPERATION

Remote Control

All band parameters as well as control settings can be set externally.

To see remote control status refer to the status display.

Protocol

To select a remote control protocol, press key C from the status display menu. Select either “RS 232”, “RS 422” or “MIDI”. This will determine which port at the rear of the EQ1 is active. The other inactive ports will be ignored.

Press the “menu” key to return to the status dis- play if you do not want to change remote on/ off status.

When selecting a port other than MIDI you have to specify the baud rate. Refer to the remote control software manual for correct settings. The set baud rate is displayed to ensure proper set- up.

Channel

To change the remote control channel number, press key C (adjacent to the remote control field). Use the “gain/ data” encoder to select a value between 1 and 16. Press the “menu” key to re- turn to the status display.

The EQ1 does not support poly-mode (listening on all channels). Select the same channel on the controller software as is set internally, else no remote control messages will be received.

On/ Off

To enable or disable remote control, press key C (adjacent to the remote control field). Press it again to toggle the “ON/ OFF”-value.

While remote control is off, data will still be sent to the selected port. Also, the MIDI THRU output will always mirror the MIDI IN input data re- gardless of “ON/ OFF” or protocol status.