PRACTICAL
GUIDE TO THE
EDIROL
Record the band performance in one shot with four channels
Because you can record four channels simultaneously, you can record all four parts (vocals, guitar, bass, and drums), each on a separate channel, at the same time.
You can also connect microphones or instruments directly into the four combo input jacks without using a mixer.
After recording, you’ll be able to adjust the volume of each part, allowing you to check the performance of individual parts. This is convenient, since it allows you to check your own part as well as listen to the entire band’s practice session.
Matching the recording levels
You can have a more perfect recording by setting recording levels for each part. You can achieve good balance by first adjusting the microphone for the drums, then the bass, guitar, and vocals, in that order. Also, if you turn on the [LIMITER], described above, you can prevent clipped sounds when there are very loud sounds.
Connections and Settings
You should connect microphones and instruments to the
Vocals must be output from PA equipment or an amp, so set the
Also, you should use a microphone to record the sound from the guitar amp so that the characteristics of the amp sound can also be recorded.
☞For details on Output Sel settings, refer to the owner’s manual.
Situation Practical 1 Use Technique
Drums
|
| Bass | Vocal | Guitar | ||||
|
|
|
| Guitar Amp/ | ||||
|
|
|
| Bass Amp | ||||
|
|
|
| 4 Channel (Drums) | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| 3 Channel (Bass) | |||
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| 2 Channel (Guitar) | ||||
1 Channel (Vocals) |
|
|
|
|
|
| ||
|
|
|
|
|
| |||
|
|
|
|
| 1 Channel (Vocals) | |||
to PA system or amp |
| |||||||
|
|
|
|
|
| |||
| LINE OUT |
|
| COMBO INPUT Jack | ||||
| (RCA Pin) |
|
| (Standard phone plug) | ||||
2 Applied Technique 3 Appendix
9
