LC-NB2UW
19
1
Complete the peripheral connections (with Computer, VCR,
and etc.) before turning on the projector. (Refer to
“CONNECTING TO THE PROJECTOR” on Pages 10-13 f or
connecting those equipment.
2
Connect the projector’s AC power cord into a wall outlet. The
LAMP indicator lights RED, and the READY indicator lights
GREEN.
3
Press the power ON-OFF button on the Remote Control Unit or on
the Top Control to ON. The LAMP POWER indicator dims , and the
Cooling Fans start to operate. The Preparation Displa y appears
on the screen and the count-down starts. The signal from the source
appears after 30 seconds.
1
Press the power ON-OFF button on the Remote Control Unit or
on the Top Control, and the message “Power off?” app ears on
the screen.
2
Press again the power ON-OFF button to turn off the projector.
The LAMP indicator lights bright and the READY indicator tur ns
off. The Cooling Fans operate for 90 seconds after the projector is
turned off. (During this “Cooling Down” period, this appli ance
cannot be turned on.)
3
When the projector has finished cooling the, READY
indicator turns to green again and you can turn the projec tor on.
After cooling down completely, disconnect the AC power cord.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU TURN IT ON, WAIT AT LEAST 5
MINUTES BEFORE TURNING IT OFF.
When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait
at least 5 minutes before turning the projector on again.
If the TEMPERATURE WARNING indicator continues to flash, f ollow procedures below:
1. Disconnect the AC power cord from the AC out let.
2. Check the air filters for dust accum ulation.
3. Clean the Air Filter. (See “AIR FILTER CARE AND CLEANING” section on page 33.)
4. Press the power ON-OFF button to ON.
If the TEMPERATURE WARNING indicator still continues to f lash, call your authorized dealer or service
station.
NOTE: The Cooling Fan may work for cooling while the projector is turned off. When the Cooling Fan is
working, TEMPERATURE WARNING INDICATOR flashes red.