Eiki LC-VC1 owner manual Turning On Projector, Turning Off The Projector

TURNING ON PROJECTOR

1 Complete the peripheral connections (with Computer, VCR, etc.) before turning on projector. (Refer to “CONNECTING TO PROJECTOR” on Pages 11~-13for connecting that equipment.)

2 Connect the projector’s AC Power Cord into an AC outlet and turn MAIN ON I OFF SWITCH to ON. LAMP Indicator lights RED, and READY Indicator lights GREEN.

NOTE : When “On start” function is ON, this projector is turned on automatically by switching MAIN ON / OFF SWITCH on. (Refer to page 37.)

3 Press POWER ON-OFF button on Top Control or on Remote Control Unit to ON. LAMP Indicator dims, and Cooling Fans start to operate. Preparation Display appears on a screen and the count-down starts. The signal from the PC or Video source appears after 30 seconds.

TURNING OFF THE PROJECTOR

1. Press POWER ON-OFF button on Top Control or on Remote Control Unit, and the message “Power off?” appears on a screen.

2 Press POWER ON-OFF button again to turn off projector. LAMP Indicator lights bright and READY Indicator turns off. After projector is turned off, Cooling Fans operate (for 90 seconds). During this “Cooling Down” period, this appliance cannot be turned on.

3 When projector has cooled down, READY Indicator turns to green again and you can turn projector on. After cooling down completely, turn MAIN ON / OFF SWITCH to OFF and

disconnect AC Power Cord.

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU

TURN PROJECTOR ON, WAIT AT LEAST 5

MINUTES BEFORE TURNING IT OFF.

When “Power Management” function is ON, projector detects signal interruption and turns off Projection Lamp automatically. Refer to “Power Management” on page 37.

When WARNING TEMP. Indicator flashes red, projector is automatically turned off. Wait at least 5 minutes before turning on

projector again.

When WARNING TEMP. Indicator continues to flash, follow procedures below:

1.Turn MAIN ON / OFF SWITCH to OFF and disconnect the AC Power Cord from a AC outlet.

2.Check Air Filters for dust accumulation.

3.Clean Air Filters. (See “AIR FILTER CARE AND CLEANING” section on page 38.)

4.Turn projector on again.

If WARNING TEMP. Indicator should still continue to flash, contact the sales dealer where you purchased this projector or service center.