Eiki LC-VC1 owner manual To change the code of Projector, To change the code of the Remote Control

This function turns Projection Lamp off when projector detects signal interruption and projector is not used for a certain period in order to reduce power consumption and maintain the Lamp-life. (This projector is shipped with this function ON.)

Power Management function operates to turn Projection Lamp off when the input signal is interrupted and projector is not operated over 5 minutes. This function operates as follows;

1. When the signal is interrupted, “No signal” and the counting down display appears (for 5 minutes).

2. When Projection Lamp turned off, READY Indicator turns off. Cooling Fans operate and Projection Lamp is turned off for 90 seconds. (During this “Cooling Down” period, projector cannot be turned on.)

3. When Projection Lamp has cooled down, READY Indicator flashes and Projection Lamp can be turned on again (Power Management mode).

In this Power Management mode, Projection Lamp is automatically turned on when the input signal connected or projector is operated

with any button on the Top Control or on the Remote Control Unit.

.

When this function is “On,” projector is automatically turned on just by switching MAIN ON / OFF SWITCH on.

Note; Be sure to turn projector off properly (refer to the section “TURNING OFF THE PROJECTOR” on page 20.). If projector is turned off in the wrong steps, On Start function does not operate properly.

This projector has two different remote control codes; the factory-set normal code (Code 1) and the secondary code (Code 2). This switching function prevents the remote control operation mixture (jam) when operating several projectors or video equipment together. When operating projector in “Code 2,” both projector and Remote Control must be switched to “Code 2.”

To change the code of Projector:

Set the Remote control in the SETTING MENU to “Code 2.”

To change the code of the Remote Control:

Press both MENU and NORMAL buttons on the Remote Control

Unit together for over 10 seconds.

After changing the code, make sure the Remote Control operates properly.

To return to the normal code (Code 1), operate both projector and Remote Control in the ways above again.

NOTE: When batteries of the Remote Control Unit is replaced, the remote transmit code automatically returns to the normal code (Code 1).

This function is used to reset Lamp

Replace Counter. When replacing Projection Lamp, reset Lamp Replace

Counter by using this function. Refer to page 39 for operation