Setting
On start
When this function is set to “On,” the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.
✔Note:
•Be sure to turn off the projector properly (see “Turning Off the Projector” on page 22). If the projector is turned off in the incorrect sequence, the On start function does not work properly.
Lamp control
This function allows you to change brightness of the screen.
Normal | ....Normal brightness |
Auto | The brightness according to the input signal |
Eco | Lower brightness reduces the lamp power |
| consumption and extends the lamp life. |
Pointer
You can emphasize a part of the projected image with this function. Use the Point ed buttons to choose either Spotlight or Pointer and press the SELECT button. Then use the Point 78 buttons to select a size of the Spotlight (Large, Middle, or Small) or a pattern of the Pointer (Arrow, Finger, or Dot). See “Pointer Function” on page 13.
Remote control
The eight different remote control codes (Code
The same code should set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control:
While holing down the MENU button, press the IMAGE button the number of times corresponding to the remote control code for the projector. See “Remote Control Code” on page 14.
Pointer
Use the Point ed buttons to choose either Spotlight or Pointer, and then use the Point 78 buttons to switch between the options.
Remote control
51
