Eiki LC-XB33N owner manual Rear Terminal, Part Names and Functions

Part Names and Functions

Rear Terminal

①	②	③	④	⑤	⑥	⑦	⑧
				⑫		⑪	⑩ ⑨

①USB

In order to operate the computer with the remote control and use the PAGE ▲▼buttons on the remote control during a presentation, connect the USB port of the computer to the USB terminal with a USB cable (not supplied) (pp.12, 18).

②SERVICE PORT

This jack is used to service the projector.

③COMPUTER IN 1/DVI-I

Connect computer output (Digital/Analog DVI-I type) to this terminal (p.18).

④COMPUTER IN 2/COMPONENT IN/ MONITOR OUT

This terminal is switchable and can be used for input from a computer or output the incoming RGB analog signal from COMPUTER IN1 terminal to the other monitor.

Set the terminal up as either Computer input or Monitor output properly. (Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1 terminal.) (pp18,20)

⑤S-VIDEO IN

⑦AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack (pp.18–20).

This terminal outputs sound from AUDIO IN terminal (⑥ or ⑪).

⑧LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual “Network Set-up and Operation”).

⑨SD Card Slot

Insert the SD card memory (not supplied) for Memory viewer operation(refer to the owner's manual of Memory viewer).

⑩SD Card Indicator

Display the status of SD card. When inserting SD Card, the indicator lights, and when unplugging SD Card, the indicator turns off.

⑪COMPUTER/COMPONENT AUDIO IN

Connect the audio output (stereo) signal from a computer or video equipment connected to ③ or ④ to this jack (pp.18, 20).

⑫VIDEO IN

Connect the S-VIDEO output signal from video equipment to this jack (p.19).

⑥AUDIO IN

Connect the audio output signal from video equipment connected to ⑤ or ⑫ to this jack. For a

mono audio signal (a single audio jack), connect it to the L (MONO) jack (p.19).

Connect the composite video output signal to this jack (p.19).

10