Eiki LC-XB33N Maintenance and Cleaning Cleaning the Air Filters, Resetting the Filter Counter

Maintenance and Cleaning

Cleaning the Air Filters

Filter prevents dust from accumulating on the optical elements inside the projector. Should the air filters become clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the air filters immediately. Clean the air filters by following the steps below.

1	Turn off the projector, and unplug the AC power cord
	from the AC outlet.
2	Turn the projector over and remove the air filters by
	pulling the latches upward.
3	softly.Gently clean the air filters by using a brush or rinse it
4	When rinsing the air filters, dry it well. Replace the air
	filters properly. Make sure that the air filters are fully

inserted to the projector.

CAUTION

Do not operate the projector with the air filters removed. Dust may accumulate on the optical elements degrading picture quality.

Do not put anything into the air vents. Doing so may result in malfunction of the projector.

RECOMMENDATION

We recommend avoiding dusty/smoky environments when you operate the projector.. Usage in these environments may cause poor image quality..

When using the projector under dusty or smoky conditions, dust may accumulate on a lens, LCD panels, or optical elements inside the projector degrading the quality of a projected image. When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.

Air filters

Pull up and remove.

Note:

•When reinserting this air filters, be sure that the slit part is facing the outer side.

Resetting the Filter Counter

Be sure to reset the Filter counter after cleaning or replacing the filters.

1	Press the MENU button to display the On-Screen	Filter counter
	Menu. Use the Point ◄► buttons to move the red
	frame pointer to the Setting Menu icon.
2	Use the Point ▲▼ buttons to move the red frame
	pointer to Filter counter and then press the SELECT
	button. A dialog box appears showing the total
	accumulated time of the filter use, a timer setting
	option, and the reset option. Select Reset and the
	“Filter counter Reset?” appears. Select [Yes] to
	continue.
3	Another confirmation dialog box appears, select [Yes]
	to reset the Filter counter.

Select Reset and the “Filter counter Reset?” appears.

Select [Yes], then another confirmation box appears.

Select [Yes] again to reset the Filter counter.

58