2. Installation
11
2-2. Environmental Settings
Depending upon your operating environ ment, it may be necessary to set the frequency th at corresponds to your
graphics board. If you install it for the rst time or ch ange environment, set the monitor.
NOTE
• Factory default se ttings are for single display mode and Dual Li nk.
• We recommend using C olorNavigator with single display mode in landscape or ientation.
• Refer to the manu al of the graphics board.
• These envi ronment described below can be set regard less of whether or not the computer is runn ing.

Displaying Two Screens Simultaneously

It is possible to display two screens on a single monitor at the same time by using one gr aphics board with
DVI-D2 type output or two graphics boards with DVI-D output on the s ame computer.
Dual display with 1280 × 1600 resolution is the maximum display size.
How to set
1 Connect the [SIGNAL1] signal input connector and the computer using the
[DD200DL-BK] signal cable.
2 Connect the [SIGNAL2] signal input connector and the computer using the
[FD-C39] signal cable.
After connecting the cable connector s, tighten the screws of the connectors to secure t he coupling.
Connectors on the PC Signal cable Connectors on the
monitor
Signal cable (DD200DL-BK) SIGNAL1
Signal cable (FD-C39) SIGNAL2
3 Hold down the button and press the button.
DD200DL-BK
FD-C39