English
6. TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
•No picture problems : See No.1 ~ No.2
•Imaging problems : See No.3 ~ No.9
•Other problems : See No.10 ~ No.13
•Touch Panel Problems: See No. 14 ~ No.17
Problems | Points to check with possible solutions | |
1. No picture | Check that the power cord is correctly | |
• Indicator status: Off | connected. If the problem persists, turn off the | |
monitor power for a few minutes, then turn it | ||
| ||
| back on and try again. | |
• Indicator status: Blue | Check the “Brightness” setting. | |
| Switch the signal input by pressing the Input | |
| Signal Selection Button on the front control | |
• Indicator status: Yellow | panel. | |
Try pressing a key on the keyboard, or clicking | ||
| ||
• Indicator status: Flashing Yellow | the mouse. (p.27) | |
Try pressing the power of the computer. | ||
(twice for each) | ||
| ||
|
| |
2. Following messages appear. | These message appear when the signal is not | |
(Error messages shown below will | inputted correctly, even if the monitor functions | |
remain on the screen for 40 | properly. | |
seconds.) | When the image is displayed correctly after a | |
| short time, there is no problem with the | |
| monitor. (Some PCs do not output the signal | |
| soon after powering on.) | |
| Check that the PC is turned ON. | |
| Check that the signal cable is properly | |
| connected to the PC or graphics board. | |
| Switch the signal input by pressing the Input | |
| Signal Selection Button on the front control | |
| panel. | |
• Whenever an error signal message | Use the graphics board’s utility software to | |
appears, the signal frequency will be | change the frequency setting. (Refer to the | |
displayed in red. | manual of the graphics board.) | |
|
| |
|
|
30 6. TROUBLESHOOTING