E

• Do your part to conserve energy, turn off the monitor when you

are finished using it.

 

 

 

Attaching an Arm Stand to the Monitor

WARNING

•When attaching the monitor to the mount, use the enclosed screws and tighten them securely. When reattaching the monitor to the tilt stand, use the screws that was attached to the monitor.

By not doing so may result in injury or failure of the monitor. To attach the mount to the monitor, please read the instruction manual of the mount.

• Use a VESA approved arm-stand. The LCD panel requires 100 mm x 100 mm hole spacing on the arm mounting pad. The arm-stand should be able to support an object weighing 13.5 kg.

• In case of using this LCD monitor with an arm- stand in an office workspace, the arm-stand shall be chosen and used carefully:

-Use only an approved arm-stand (e.g. GS).

-The arm-stand shall have sufficient stability (mechanical firmness) to support the weight of the monitor.

-The arm-stand shall remain in that position where it is manually moved.

-The arm-stand shall have the ability to tilt the

monitor forward and backward.

- The height of the upper row shall be less

than or equal to 500 mm in relation to 500 mm the desk surface when the arm-stand is

in its lowest position.

100mm x

100 mm

(Example)

(1)Lay the LCD monitor as shown below, not scratching the panel. Remove the tilt loosening the screws. When reattaching the tilt, use the enclosed screws and fix the tilt to the monitor securely.

Soft Cloth or Cushion

1 INSTALLATION 13