Elation Professional 300 PRO

Design Spot 300 Pro™

©Elation Professional, Los Angeles Ca. 32 www.ElationLighting.com

8.6.3 Calibrate values – This function should only be performed by a qualified technician.

This function allows a user to make small adjustments to the effect wheels (color,

gobo, shutter, etc) to compensate for ware or in the event a sensor has been knocked

slightly out of place. Because improper use of this function can result in undesired

operation this function has been password protected. The password is 050 and must

be entered each time the calibration menu function is entered. Because calibration is

an extremely delicate procedure instruction on performing this action are left out of

this manual. For a first time calibrator, please contact our customer support team for

step-by-step instructions.

8.7 User Mode Set:

8.7.1 User mode – This function allows the user to create user defined channel orders

allowing the fixture to match the channel order of other fixtures on the market for

easier operation. A total of three user modes may be configured: User Mode A, User

Mode B, and User Mode C.

8.7.2 Edit User mode – This function allows the user to make the actual changes in the

user-defined modes that are created in the previous function.

8.8 EDIT PROGRAM: - The fixture comes equipped with a built-in DMX recorder that allows

custom programs to be installed and recalled directly from the fixture’s control board.

Programs can be created and stored using the fixture’s control board or by using an

external DMX controller. For detailed instructions on how to complete this task please

see Section 11/ Page 37.

8.8.1 Select program – This function allows the user to select one of ten of the user

defined built-in programs. This program is then accessed in “Function Mode” under

“Program Run.”

8.8.2 Edit program – This function allows the user to edit the built-in programs.

8.8.3 Edit Scenes – This function allows the user to edit or define the actual scenes that

are stored in the user defined built-in programs that are accessed in the previous