Installation Instructions 15
Water connection (Steam Model only)
WATER SUPPLY REQUIREMENTS
Cold water faucet MUST be installed within 42 inches (107 cm) of your dryer’s water inlet. The faucet MUST be 3/4 inch (1.9 cm) with thread- ing for laundry hose connection. Water pressure MUST be between 30 and 120 psi. Your water department can advise you of your water pressure.
1.Turn off COLD water supply to washer,
2.Remove COLD inlet hose from COLD water supply and inspect for rubber washer. Replace washer if it is torn or worn out.
RUBBER WASHER
MUST BE PRESENT
AND UNDAMAGED
COLD INLET HOSE
TO WASHER
3. Momentarily turn on COLD supply and run some water into a bucket or container to clear any contaminants in the line.
4.Remove hose kit from dryer drum and inspect hose couplings for proper placement of rubber washers.
