Reversing Door 19
Preparing to reverse door swing
1Be sure you have adequate swing area before reversing door.
2You will need a screw driver with a #2 square bit.
3Protect flat work surface, such as top of dryer or floor near dryer, with a soft cloth or towel.
4Be sure dryer is unplugged from power source!
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing could result in personal injury or even death.
Removing door and hardware
Tools needed: |
Screwdrivers with |
#2 square & |
straight bit |
A) Removing Trim Ring
1Open door to 90 degree angle.
2Remove and save trim plug and long,
B) Removing Door from Hinge
1Reopen door to 90 degree angle.
2Remove 4 long,
3Close door.
4Rotate door trim approximately ¾” counter- clockwise and pull ring away from door.
3While supporting the weight of the door with both hands, separate the door from the hinge.
4Gently place door face down on flat, covered work surface.
