Setting the amount of rinse aid required

3 Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from 1-6. The dosage is pre-set to “4” in the factory.

1.Open the dishwasher door.

2.Press the release button on the rinse

aid compartment.

3.Open the cover.

4.Set the dosage level.

5. Press the lid shut until it clicks into place.

6. If rinse aid has leaked out, wipe it away with a cloth.

Activating/deactivating the inflow of rinse aid

1.Press the ON/OFF button.

3 If indicators for the programme buttons are lit, a dishwashing cycle is activated. The cycle must be deactivated:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds. All other indicators will go out.

2. Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 2 .

The LED indicator for function button 2 will flash.

The indicator for the end of the dishwashing cycle will display the cur- rent setting:

4.Pressing function button 2 activates and deactivates the rinse aid dis- pensing function.

5.When the rinse aid inflow setting is correct, press the ON/OFF button. The setting for the rinse aid inflow is now saved.

11