Prior to using for the first time
1.Set the water softener
2.Fill up with special salt for water softeners
3.Fill up with rinse aid
3 If you wish to use 3in1 detergent, do the following:
–First read the section “Using 3in1 detergents”.
–There is no need to fill up with special salt or rinse aid.
–Set the water softener to water hardness range “I”.
–Deactivate the rinse aid inflow. For dishwashers where the rinse aid inflow cannot be deactivated, set the rinse aid dosage to “I”.
–Before the start of the dishwashing cycle put 3in1 detergent in the detergent dispenser.
–The drying result may be affected.
Setting the water softener
The water softener must be set manually and electronically:
3 To avoid scale deposits on the dishes and in the dishwasher, the dishes must be washed with soft water, i.e. water with a low lime content. The water softener must be set according to the table to the water hardness in the area where you live. Your local water company will be able to give you information about the water hardness in your area.
The dishwasher must be switched off.
Setting manually:
1.Open the dishwasher door.
2.Remove the lower basket from the dishwasher.
3.Turn water hardness dial on the left wall of the dishwasher interior to O or 1 (see table).
Setting electronically:
1. Press the ON/OFF button.
3 If indicators for the programme buttons are lit, a dishwashing cycle is activated. The cycle must be deactivated:
Press function buttons 2 and 3 simultaneously for approx. 2 seconds. All other indicators will go out.
7