Electrolux 45250Vi manual Mounting the outer door, Fitting protective and cap, strips

Position and connection instructions

Mounting the outer door

1. Unscrew the screws on the mount plate. Lift the plate off together with the door.

2. Lay the machine down on its back. Check that none of the hoses are trapped. Insert the guide rods into the plastic door guides.

3.Slot the tabs on the mount plate into the holes on the front plinth of the machine and screw the mount plate into place using the 2 screws provided.

Fitting protective and cap	Tab
strips

In order to fill the gap between the cup- board and the dishwasher and to protect the cupboard above from any steam that comes out of the washer, a self-adhesive protective strip is attached along the upper edge of the cupboard and two gap strips are attached along the edge of the cupboard.

1. Clean all surfaces where the strips are to be attached to ensure better adhesion.

2.Attach the protective strip along the upper edge of the cupboard. If it is too long, it can easily be cut to the right length.

3.Attach the two gap strips along each side of the cupboard, level with the front edge of the sides.

31