Instruction book
Adjusting rinse aid dosing
The dispenser holds about 150 ml. This is enough for approx. 60 wash cycles, depending on the dosage setting. Adjust the dosage setting according to the hardness of the water.
You can set the dosage between 1 - 6, equivalent to 1 - 6 ml rinse aid. Factory setting is 1. Begin at the lowest dosage setting and increase if necessary by turning the setting arrow with e.g. the handle of a spoon.
Filling with detergent
Caution!
Only use detergents specially designed for dishwashers.
The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommendations as stated on the detergent packaging. Remember that the instructions usually refer to
1. Open the lid to the dispenser by pressing the lid catch towards the compartment.
2. Filling with detergent.
3. Close the lid.
Detergent tablets
Detergent tablets of different makes dissolve at different speeds. For this reason some detergent tablets cannot develop their full cleaning power during short programmes. Therefore please use normal programmes with
13