Instructions for use

End of Wash Cycle/Removing the Washing

When a wash cycle is completed, the END (FIN/EINDE) light on the Programme Progress Display comes on.

If RINSE HOLD (ARRET CUVE PLEINE/SPOELSTOP) was selected, the indi- cator lights DOOR (PORTE/DEUR) and END (FIN/EINDE) come on.

1.After a Rinse Hold, the water must first be drained:

Either turn the programme knob to OFF (ARRET/UIT), then to DRAIN (VIDANGE/POMPEN) and press the START/PAUSE (MARCHE/PAUSE, START/PAUZE) button (the water is drained without spinning),

or

turn the programme knob to OFF (ARRET/UIT), then to SPIN (ESSORAGE/CENTRIFUG.) and press the START/PAUSE (MARCHE/ PAUSE, START/PAUZE) button (the water is drained and the washing is

given a spin; the spin speed can be altered during the spin).

When this stage of the programme is completed, the END (FIN/EINDE) light comes on.

2.Opening the door.

The door can be opened after the DOOR (PORTE/DEUR) light goes off and the END (FIN/EINDE) light has come on.

3.Take out the washing.

4.Turn the programme knob to OFF (ARRET/UIT).

5.Close the stopcock.

6.After the wash cycle is completed, pull out the detergent/additives drawer slightly to allow it to dry. Leave the door slightly open to air the inside of the washing machine.

Attention! If the washing machine is not used for a long time: Close the water tap and disconnect the washing machine from the electricity mains.

25

Page 25
Image 25
Electrolux 50550 manual End of Wash Cycle/Removing the Washing, After a Rinse Hold, the water must first be drained