What to do if ...
29
.... the cooking zones do not heat up, even though the displays
are working?
0 Check whether
–demonstration mode has been activated accidentally.
To deactivate this mode, ensure that the appliance is switched off and
that the control panel is not locked.
Then proceed as follows:
1. Switch on main button.
2. Within 10 seconds, press the following buttons simultaneously for a
maximum of one second:
–Lock button o
–Cooking zone selection button, front left
–Cooking zone selection button, rear left.
When the buttons are released, a peep tone sounds as confirmation.
3. Press the j button, a peep tone sounds as confirmation.
Your cooking surface is now ready for use again.
.... the display suddenly changes to j or h for residual heat?
0Check whether
–the On/Off button has been operated accidentally.
–the touch switches are partially covered by a damp cloth, liquid or
similar.
–there has been a power cut.
–the safety switch has been activated.
.... after switching off the cooking zones, neither j nor h for
residual heat appears in the display?
0Check whether
–the cooking zone was only used for a short period and is therefore
not hot enough.
If the cooking zone is hot, call AEG customer service.
.... a cooking zone cannot be switched off?
0Check whether
–the touch switches are partially covered by a damp cloth or liquid.
–the lock is activated.
.... a cooking zone cannot be switched on?
0Check whether
–the lock is activated.