Electrolux CF921BS00, CF921ORB00 Installation of Remote Control Battery, Preset Memory Feature

Installation of Remote Control Battery

Your Emerson Ceiling Fan/Light SR600 Remote Control consists of hand-held transmitter and a receiver which is mounted under the fan ceiling cover. The remote control is designed to separately control your ceiling fan speed, airflow direction and light intensity.

The remote control transmitter is powered by two

AAAalkaline batteries (included). To prevent possible damage if the batteries should leak, be sure to remove the batteries when the control is not to be used for an extended period of time.

Code switches in the transmitter and receiver may be set in 32 different positions. If your fan and light go on and off without using your control, you may be getting interference from other remote units such as garage door openers, car alarms or security systems. To remedy this situations, simply change the combination code in your transmitter and follow procedures for Setting Operating Frequency of Remote Control.

Preset Memory Feature

Your Emerson receiver is equipped with a preset memory feature. If the AC supply to the receiver is powered through a wall switch, when the switch is turned OFF, the control will remember the light intensity and fan speed. When the switch is turned back ON the light and fan will resume operation as they were prior to the switch being turned OFF.

1.Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 13).

2.Install two AAA alkaline batteries and reinstall the battery cover.

REMOTE CONTROL

LEVERS

					ON
1	2	3	4	5	I

TWO AAA

BATTERIES

CODE

SWITCHES

BATTERY	SR600 REMOTE
COMPARTMENT
	CONTROL
COVER

Figure 13

Setting Operating Frequency of Remote Control

Your remote control has code switches which must be set in one of 32 possible code combinations. The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) positron. Change the switch settings as follows (Figure 14).

1.Slide the five switch levers in the remote control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up and down.

2.When power is restored, push and hold the fan

OFF button ( ) for 3 to 5 seconds to set the code in the reliever.

NOTE: The remote/receiver must be programmed within 2 minutes of restoring electricity to the fan.

3.The ceiling fan lights will blink when the receiver has completed programming.

4.If programming fails, shut off and turn on the electricity at the wall switch to reset the receiver. Repeat Step 2 above.

5.If programming continues to fail, change the remote code and repeat Steps 2 and 5 as necessary until the fan successfully completes the programming procedure.

Figure 14

11 ETL Model No.: CF921