EMERSON QUICK START GUIDE
The Quick Start Guide covers the installation | ! | WARNING | |
instructions common for ceiling fan operations. If | |||
|
| ||
additional assistance with wiring, alternate hanging | To reduce the risk of fire, electric shock, or personal | ||
systems, or lighting options, proceed to the complete | injury, mount fan to outlet box marked “Acceptable for Fan | ||
instructions of this Owner’s Manual. | Support of 22.7 kg. (50 lbs.) or less”, and use screws | ||
The Quick Start Guide sections include page numbers | supplied with outlet box. Most outlet boxes commonly used | ||
to correspond with the appropriate sections of the | for support of light fixtures are not acceptable for fan | ||
Owner’s Manual for detailed instructions. | support and may need to be replaced. Consult a qualified | ||
* See Unpacking Instructions for a complete list of | electrician if in doubt. |
| |
parts for installation. |
|
| |
Installation of Downrod (page 6) | Installation of Ceiling Fan (page 7) | ||
1. Remove the hanger ball from | 1. Install the coupler cover and | ||
the downrod. | ceiling cover onto | the | |
2. Install the downrod to the | downrod. |
| |
2. Reinstall the hanger ball onto | |||
motor coupling using the | |||
the downrod, place the pin | |||
clevis pin and hairpin clip. | |||
into the hanger ball and | |||
3. Tighten the setscrews. | |||
tighten the setscrew. |
| ||
Installation of Blade Assembly (page 7) | Installation of Switch Housing (page 8) | |
1. Mount blade flanges to fan | 1. Remove the four switch | |
blades (sold separately) using | housing mounting screws | |
four | from the switch housing | |
head blade screws. | plate. Position the switch | |
2. Loosely attach one blade | housing assembly on the | |
switch housing plate and | ||
assembly to the motor hub | ||
align the holes in the switch | ||
using two | ||
housing assembly with the | ||
captive screws with lock- | ||
holes in the plate. Secure the | ||
washers. Make sure the | ||
switch housing assembly by | ||
screws are NOT tightened. | ||
installing the four screws. | ||
Repeat this procedure for | ||
NOTE: Tuck in both the blue and white wires carefully under the | ||
other four blade assemblies. | ||
| switch housing cover | |
Hanging Your Ceiling Fan (page 9) | ||
1. Disconnect electrical power to | CEILING |
the branch circuit at the |
|
circuit breaker or fuse box |
|
before attempting to install | AT LEAST |
the ceiling fan hanger bracket | 7' |
on the outlet box. | FLOOR |
|
!
WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
2.The fan must be hung with at least 7’ of clearance from floor to ceiling.
3.Attach the hanger bracket to the outlet box.
4.Seat the hanger ball/downrod assembly on the hanger bracket.
3 | ETL Model No.: CF921 |
