Electrolux CF921GES00 Unpacking Instructions, Install, Operate and Maintain Your Ceiling Fan

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver	One stepladder
One 1/4” blade screwdriver	One wire stripper

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following size:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

! WARNING

Before assembly your ceiling fan, refer to section on proper method of wiring your fan (page 10). If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

Unpacking Instructions

! WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

! WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1.Check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor assembly

b.One switch housing assembly

c.One ceiling cover

d.Five blade flanges

e.One hanger ball/downrod assembly

f.One hanger bracket

g.One coupling cover

h.One remote control

i.One loose parts bag containing:

1.Twenty-one #10-24 x 12mm washer head blade screws

2.One 1/4-20 x 14 captive screw with lockwasher

3.One #8-32 x 8mm flat head screw

4.One #8-32 x 8mm pan head screw

5.Three wire connectors

6.Two threaded studs

7.Two knurled knobs

8.Two lockwashers

9.One clevis pin

10.One hairpin clip

11.One balancing kit

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

2.Remove the fan assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the bottom of the motor facing up.

The upper foam pad serves as a holder for the fan during the first stages of assembly.

	i. LOOSE
	PARTS BAG	a. FAN MOTOR
		ASSEMBLY
		f. HANGER
		BRACKET
		e. HANGER BALL/
		DOWNROD
		ASSEMBLY
	d. BLADE	b. SWITCH
	FLANGES
		HOUSING
		ASSEMBLY
		g. COUPLING
		COVER
c. CEILING		h. REMOTE
		CONTROL
COVER

5 ETL Model No.: CF921