HOW TO FINISH UNPACKING
Place packed appliance next to the cabinet in which it will be installed.
Remove the appliance packing except for bottom tray which should be left in position until the appliance is ready to be fitted into its cabinet.
It is imperative that the appliance is left in the base to protect both the appliance and the floor.
Ensure the user is given these operating instructions.
TOOLS REQUIRED
The following tools will be needed and it helps to assemble them before starting to install the oven:-
A terminal screwdriver (3mm wide blade)
A pozidrive screwdriver
Pliers
Wirestrippers
Knife
Sidecutters
Adhesive Tape
Tape Measure
MAKING THE ELECTRICAL CONNECTIONS
Important: Switch off at mains,
miniature circuit breaker and, if appropriate, remove fuse before commencing any electrical work.
PREPARING CABLE
We recommend you use a new length of cable to ensure your safety.
Ensure you have the correct length of cable appropriate to the wiring method you are using. When fitting new cable allow sufficient cable for removal of the unit at a later date, should it be necessary.
Score, but do not cut through, around the sheathing with a knife 100mm (4in) from each end of the cable and break through to the encased wires by bending the cable backwards and forwards to fatigue the sheathing.
Carefully score down from each end of the cable sheathing along the length of the bare earth wire (if a cut was made along the length of the live and neutral wires, it might cut into their sheathing) to the cuts already made.
Carefully prise open the sheathing at each end of the cable to expose the encased wiring.
43
