Ignition System / Gas Ignition

Check gas supply at burner

Check plug top fuse and

replace if necessary

Check polarity and earth continuity of supply point

Check earth continuity of appliance

Check continuity from 'N' on the mains connector block and "O" on the ignitor unit

Check continuity from 'L' on the mains connector block and the taps ignition switches

Check continuity from ignition switches connector to ignitor unit

Check continuity from the tip of each electrode to the terminals 1 to 4 on the ignitor unit

Check for breaks in the insulation

of the HT leads

Change the taps ignition switches

Light burner manually

Check by pass simmer adjusted

Check position of the electrode

Check fitting of burners

Change the ignitor unit

Image 14

Contents

Instruction Booklet Important Safety Information Contents Description of the Hob Burner Minimum Maximum Diameter OperationHob burners Burner cap Burner crown Ignition electrode Thermocouple Burners Maintenance and CleaningHob Top Ignition electrode Cast Iron Pan Supports Symptom SolutionSomething Not Working? Guarantee Conditions Instructions for the Installer Engineers technical data Location Important safety requirementsProvision for ventilation Gas Connection InstallationWhen the HOB is First Installed Cut Out Size Building over a kitchen unit with door BuildingBuilding over a cupboard or drawer Fitting the Hob into the worktop This HOB Must be Earthed Supply cable replacementElectrical connections Permanent Connection Ignitor Switch Ignitor Unit Wiring DiagramFault Finding Preliminary Electrical Systems Check Ignition System / Gas Ignition Page Customer Care