24Care & Cleaning
Inside Cleaning (Aggressive)
In cases where CLEAN WASHER cycle along with care and cleaning of rubber gasket folds isn’t done, and severe odor, mold, mildew, or residue buildup have developed, follow the below cleaning procedure to help alleviate the problem.
CLEANING PROCEDURE - Washer Drum
Ensure the wash tub is empty (or no clothes load). Open the detergent drawer and pour eight (8) cups of bleach into the “MAIN WASH” detergent compartment. Select CLEAN WASHER cycle as described previously in Inside Routine Cleaning (Preventative).
Upon cycle completion inspect the interior of the washer to see if the odor/residue has been eliminated. If any additional cleaning is required, repeat the above procedure. This may take several cycles depending on the severity of the odor/residue. You may observe some remaining discoloration due to the long term effects of this residue.
For especially contaminated areas visible inside the drum (including the front rubber seal), these areas might be more effectively cleaned by spraying a Bleach Cleaner on a scrub brush, soft sponge, or towel and scrubbing.
IMPORTANT
Always wear rubber or latex gloves and protect floor and clothing from damage.
If odor is still left after bleach cycle(s) and bleach cleaner, open the detergent drawer and pour one (1) pouch of TIDE® WASHING MACHINE CLEANER in detergent drawer. Select CLEAN WASHER cycle as above and start the washer.
For best results
REMOVE “LIQUID ONLY”
DISPENSER CUP
“MAIN WASH”
COMPARTMENT
WARNING
HARMFUL VAPOR HAZARD
Do not use or mix liquid chlorine bleach with other household chemicals such as toilet cleaners, rust removers, acid or products containing ammonia. These mixtures can produce dangerous fumes which can cause serious injury or death.
Immediately follow up with a Spin Only cycle. Select fresh rinse on max spin
speed with no detergent or bleach to help clear any residual bleach left after the CLEAN WASHER cycle.
IMPORTANT
See Inside Routine Cleaning (Preventative) for future cleaning maintenance which is necessary to avoid repeating issues.
NOTE
If the CLEAN WASHER cycle is cancelled or paused during the cycle, the washer will go through 2 rinse cycles to clean the drum of any residual bleach before unlocking the door.
