Toshiba IP5000 manual Station Call Forward Procedures, To use the Call Forward button sequence

Feature Operations

Call Forward

Station Call Forward Procedures

Table 19 on Page 151 contains Call Forward Button sequences. You can do a Call Forward function by entering the button sequence as described or by programming a Programmable Feature Button to perform the sequence. See “Programming Feature Buttons” on page 96 to program a Programmable Feature Button.

To use the Call Forward button sequence

Follow the instructions in Table 21 on Page 156, shown under the “Button Sequence” heading. Some features require additional input, such as:

•Dest. Ext. or Telephone No. – Call Forward destination numbers can be internal extension numbers or outside telephone numbers. If the destination is an outside number, enter the access code used for dialling out (such as 9) + the telephone number + #. The CIX accepts destination numbers of up to 32 digits.

•Timer – Enter the number of seconds (08~60) your telephone should ring before forwarding the call. (This is the Call Forward-No Answer timer.)

•Call Forward Pass Code – A four-digit Call Forward pass code can be setup by your System Administrator and will allow one station to activate the call forward setting for another station. Users must enter the Call Forward pass code for the station to be forwarded.

Note In Table 19 on Page 151, (tone) refers to three short tones used as a confirmation tone and will play at that point in the sequence to confirm your input was accepted.

44 Strata CIX IP5000-series Telephone UG 10/08