Administrator Programming
IP Setup Instructions
IP Setup Instructions
The following steps must be completed before starting the telephone setup. The IP password will be assigned by the Telephone Administrator and is the verification step of the telephone registration with the CIX (xIPU).
To enter the Password
1.Press 3+6+9+
(simultaneously).
2.Press 2, then press 
for the Network Setting Mode.
3.Press Next (for 20 button phone)
...or Next Next (for 10 button phone).
4.Press FB26, then enter the Password.
5.Press 
.
6.Lift the handset
Telephone Setup
1.Press 3+6+9+
(simultaneously).
2.Press 2, then press 
to select the Network Setting Mode.
3.Press FB1 to see if the DHCP server is in use or not. Press one of the following (normally, use 1: manual setting):
1: manual setting, then press 
.
2: auto setting by DHCP server, then press 
. Go to Step 7 below.
4.Press FB2. Enter the IP address for this IP endpoint and press 
. To enter the period in an IP address, press the * button on your dialpad (e.g., if the IP address is “192.168.1.241,” press 192*168*1*241).
5.Press FB3. Enter the subnet mask number and press 
. (e.g., if the subnet mask address is “255.255.255.0, press 255*255*255*0).
6.If the IP endpoint is connected to a router or other gateway device, press FB4.
Enter the router address, then press 
. Only used if Step 3, above, is set for manual setting.
7.Press FB5. Enter a Station ID for the IP endpoint and press 
. This is usually your telephone’s primary number (PDN).
106 | Strata CIX |
