Toshiba IP5000 manual Red LED must be on in order for button to function

The Grand Tour

IP5000-series Telephone Overview

The Fixed buttons are described below.

Table 3 Fixed Button Definitions

Button	Definitions
Message (Msg): When Msg LED flashes, press Msg to call back the
station or voice mail device that activated the LED. This is the
telephone’s [PDN] message waiting button.
Important!	Red LED must be on in order for button to function.

Microphone (Mic/Mute) button toggles between Mic and Mute. When Mic key is lit, Mute is disabled. When Mic is pressed again and light is off, Mute is enabled on the microphone in the telephone and the microphone in the handset.

Speaker: Press to toggle the speaker ON/OFF. When red Speaker LED is lit handsfree communications is supported.

To start a handsfree conversation; press the Speaker button, this turns the red Speaker LED on. To terminate this call press the Speaker button again (Speaker LED off).

During a handset conversation, press the Speaker button to start hands-free communications (red Speaker LED on). Press the Speaker button again to transfer the conversation back to the handset (Speaker LED off).

Press and release the volume control bar to adjust volume levels. See “Volume Control” on page 13.

Important! Continuously holding the volume button (up or down) does not change the volume. It is adjusted on a per press basis.

Navigation Key: Round button on the IP5131-SDL telephone is a navigation key used for moving the cursor on html pages and in the programming screens. Center of the button is the “select” function. The arrows are used to scroll up, down, left or right.

6 Strata CIX IP5000-series Telephone UG 10/08