Toshiba IP5000 107, To manually set up the Vlan ID

Administrator Programming

IP Setup Instructions

8.Press FB6 to enter the CIX Strata Net node number of the CIX node that contains

the xIPU to which this IPT interfaces, then press . This FB setting is for CIX networked systems only.

9.Press FB11 for xIPU IP address mode. Press one of the following:

1: manual setting, then press . Press FB12 and enter the xIPU IP address,

then press . (e.g., if the xIPU IP address is “192.168.1.241,” enter it in this format 192*168*1*241).

2: auto setting by broadcast, then press .

10.Press again to set all the above data.

11.Go off-hook and hang up. The IP endpoint will search for the xIPU, initialise and then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on LCD when the information is set.

Notes

•See Table 15 on page 109 for an explanation of the LCDs that you will see during this procedure.

•If registration fails, check with the Administrator for the correct password (FB26).

To manually set up the VLAN ID

The following steps are for manually setting the VLAN ID in an IPT. If this system is not using VLAN tags or is using only the default (VID = 1) value, these steps are not required.

1.Press and then 3+6+9+ (simultaneously). The display will show “Program Select =”

2.Press 2, then press the soft key Scrl until FB21 is indicated.

3.Press FB21 for VLAN Enable/Disable; 1 = Enable VLAN, 2 = Disable VLAN.

4.Press FB22 to enter the VLAN ID (1 – 4094) for this phone.

5.Press FB23 set the PC Port Type, 1 = Access, 2 = Trunk.

6.Press FB24 to enter the PC Port VLAN ID (1 – 4094).

Strata CIX IP5000-series Telephone UG 10/08 107