22electrolux
It is essential that the appliance is positioned as Fig 1. a.
Shelves, wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top of the hotplate (or greater for cooker hoods if recommended by manufac- turers instructions) and 400mm above the hotplate when fitted in line with the outside of the appliance.
If the units are intended to be fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of 50mm must be maintained between the sides of the unit and the appliance as Fig 1.b. Curtains must not be fitted immediately be- hind the appliance or within 150mm of the sides of the hotplate.
If fitted next to or between two base units a minimum space of 2mm must be left be- tween each unit and the sides of the appli- ance.
The levelling feet fitted to the appliance will achieve a nominal height to hotplate of 907mm + / - 5mm.
Fig 1.a | Fig 1.b |
L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any boat, yacht or other vessel.
Levelling the appliance
Adjustment to suit floor conditions or height is obtained by rotating clockwise or anti clockwise the feet at the front and rear of the appliance.
A spirit level should be placed on one of the shelves to confirm the appliance is correctly levelled.
Connecting to the electricity supply
Warning! This appliance must be earthed. Do not earth this appliance to the gas supply piping. Connect to 230 - 240V AC supply only.
Connection to the electricity supply should be made via a properly earthed, readily ac- cessible wall socket. Which is adjacent to, but not directly above and not more than 1.7m away from the appliance and capable of electrical isolation.
The cooker point should be within 1.7m of the appliance to make it accessible to switch off the appliance in case of emergency. The mains lead should be routed so that it cannot touch hot parts of the cooker i.e. the back panel above a height of 650mm from the floor. Should this plug not fit the socket outlet in your home it should be cut off and replaced with a suitable plug as outlined be- low.
If the supply cord is damaged, it must be re- placed. Please contact your local Service Force Centre.
If the moulded plug is cut from the cable for any reason it must be destroyed or disposed of safely, as protruding wires will be an elec- trical shock hazard.
If the fitted plug is removed.
The flexible mains lead must be correctly connected as below to three pin plug of not less than 13amp capacity.
If a B.S. 1363 fused plug is used, it must be fitted with a 3 amp fuse which is approved to B.S. 1362.
Important: The wires in the mains lead fitted to the appliance are coloured in accordance with the following code.
•GREEN AND YELLOW = EARTH
•BLUE = NEUTRAL
•BROWN = LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the termi- nals in your plug, proceed as follows:- The wire which is coloured green and yellow must be connected to the terminals in the plug which is marked with the letter E or by the earth symbol ( 
) or coloured green or green and yellow.
