Installation and connection instructions
55
Inlet Hose Connection
A pressure hose 1.5m in length is supplied.
If a longer inflow hose is required, only a VDE-approved, complete set
of hoses with fitted hose screw connections offered by your local Serv-
ice Force Centre is permissible.
–Hose sets in lengths of 2.2m, 3.5m and 5 m are available for washing
machines without Aqua Control.
–Hose sets in lengths of 2.0m, 2.9m and 3.9 m are available for wash-
ing machines with Aqua Control.
Important! Never cut hoses into pieces in order to extend them!
3 Sealing rings are supplied either in the plastic
nuts of the hose screw connection or in the
enclosed pack. Do not use other seals!
0 1.Connect the hose with the angled
connection to the machine.
Important!
–Do not lay the inlet hose verti-
cally downwards. Instead, turn
it to the right or left as shown
in the diagram.
–Tighten firmly to prevent
leakage but do not use
excessive force.
2. Connect the hose with a straight connection to a
water tap with a screw thread R 3/4 (inches).
Important! Only tighten the screw connection
manually.
3. By slowly opening the water tap before putting
the washing machine into operation it is possible
to check that the connection is free of leaks.