Drying cycle lasts an unusually long time. Note: After around 5 hours the drying cycle ends automatically (see „Drying cycle complete ”).
Discoloration
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temperature. Temporary switching off of the com- pressor to avoid overload.
Colour fastness of tex- tiles.
electrolux 49
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately spun.
Automatic process, there is no fault with the appli- ance. If possible, lower the room temperature.
Check colour fastness of textiles. Only treat textiles together if they are a simi- lar colour.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be obtained from the Customer Care Department, ET no. 112 552
When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open.
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug.
1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)
2.Replace defective bulb.
3.Screw cover back down.
