36electrolux
The higher the spin speed was, the shorter the programme length for the drying cycle.
Activate the SPIN SPEED option and then number of times press OPTION button until the desired spin speed of the initial drainage is displayed. No value is shown if no spin speed is selected.
In certain programmes the spin speed has not effect (time controlled cycles), its selection can be not selectable and only three dashes are visualized. Available se- lections: from 800 to 1800 rpm's in 100 rpm's intervals.
The maximum value depends by selected program, the minimum is always 800 rpm For those programs where the spin speed has no effect (time controlled cycles), the selection is not allowed and three dashes “- -
The user interface always remembers last spin selection, and proposes it as default for all new selected programs. If memorized spin speed is greater than maximum allowed value it will be automatically reduced to max spin speed available for the selected program.
Selecting TIME
To select the programme duration after setting the TIME (Zeitprogramm) pro- gramme. You can select a programme duration from 10 minutes to 3 hours in 10- minute steps.
1.Turn the programme knob to the TIMED PROGRAMME (Zeitprogramm). The 0:10 minutes is in the display (corresponding to the COOLING programme).
2.Press the TIME button repeatedly until the desired programme duration is shown in the display, e.g. 0:20 for a programme of 20 minutes.
If the programme duration is not selected, the duration is automatically set to 10 mins.
Selecting DELAY START (Zeitvorwahl)
See chapter Pro Steam system, section Selecting DELAY START (Zeitvorwahl).
Starting the drying programme
Press the START PAUSE button. The programme starts.
The progress bar and the name of currently performed phase, above it, show stage of the cycle.
With wet laundry, after a few minutes the appliance will show the correct programme duration and foreseen time of cycle end.
