Electrolux 9CHG584114 manual Installation Instructions Electrical Connection, Connection Terminals

INSTALLATION INSTRUCTIONS

4.ELECTRICAL CONNECTION

Each appliance is accompanied by a complete connection and wiring diagram enclosed. This contains full details of the technical specifications (electrical rating, voltage, amperage etc.)

Check and ensure that the mains voltage agrees with the voltage given on the specification plate.

N.B.:

•The corresponding arrangements must be made on-site for the earthing connection and fuse protection for the appliances.

•The appliance must be connected to a potential

equalization system with a minimum conductor cross- section of 10 mm². The correspondingly marked connection terminal must be used for this purpose. When set up in block configuration, all appliances must be interconnected as potential equalization.

•The appliance is designed for connection to fixed lines. If the appliance is fitted directly to a masonry plinth without an appliance plinth, the supply must be located at the prescribed place. In this case, the protecting tube may not protrude from the plinth. If a CNS base is used, the protecting tube may not protrude more than 10 cm from the floor.

•After installation, the shock-hazard protection for live and functionally insulated parts must be secured.

•An isolating device working on all poles and with a minimum contact opening of 3 mm must be provided on site.

•When faulty-current circuit breakers are used, ones for a rated tripping current of 30 mA should be used.

•When using a faulty current-operated circuit-breaker (in the case of an existing circuit-breaker and for new installations) only a one pulse-current sensitive faulty current-operated circuit-breaker may be connected in series in conjunction with these appliances.

4.1CONNECTION TERMINALS

A = Mains connection

G = Appliance outgoing section

Fig.9 Connection terminals

Power is taken from a ready-installed electric cable which protrudes 1.5 m from the floor or the wall.

The connection terminals for the appliance are located behind the front right-hand cover (B). In order to connect the appliance, the front panel must be removed (see Chapter 2.1 on page 6).

Power cable connection as per the electrical diagram.

The terminal screws on the range frame are marked as follows:

4.2CONNECTION TO THE POTENTIAL EQUALIZATION SYSTEM

The appliance is to be connected to a potential equalization system with a minimum conductor cross-section of 10 mm². Use the appropriately marked terminal studs for this purpose (EN 60 335). The connection consists of an M6 threaded bolt and is located on the frame of the appliance.

Connection as per sketch.

1Cable shoe * 6 mm

2Nut M 6

3Spring washer M 6

4Washer M 6

Fig.10 Connection to the potential equalization system

Earth wire Potential equalization

Additional terminals for power optimizing systems (EO/SI) or potential-free contacts (PK) for the external monitoring of the appliance are available as options. The connections are made as per the electrical diagram.

62.9676.01_UL Page 7