1 | 2 | 3 |
4 | 5 | 6 | 7 |
8 | 9 | 10 |
11 | 12 |
English
CLEANING THE HOSE AND NOZZLE
The vacuum cleaner stops automatically if the nozzle, tube, hose or filters and
Tubes and hoses
1 Use a cleaning strip or similar to clear the tubes and hose. 2 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose.
Note: The warranty does not cover any damage to the hose caused by cleaning it.
Cleaning the floor nozzle
3To avoid deterioration of suction power, frequently clean the carpet/hard floor nozzle. The easiest way to clean it is by using the hose handle.
4Press each
5Remove
6Larger objects can be accessed by removing the connection hose (press the small catches located on each side and simultaneously draw the connection tube outwards in an upright position).
7Remove the object(s) and replace the connection hose.
Cleaning the power nozzle
(certain models only)
8Disconnect from the mains, and remove entangled threads etc. by snipping them away with scissors.
9Use a screwdriver to remove the nozzle cover.
10Remove the brush cylinder and bearings, then clean as necessary.
11To clean the wheels, gently lever them from their mountings and clean as necessary.
12Replace the cover and make sure it is securely fastened.
Cleaning the turbo nozzle
(certain models only)
13Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. by snipping them away with scissors. Use the hose handle to clean the nozzle.
12
13
7/18/07 4:32:50 PM
