This machine or any of its parts should not be altered or changed from standard specifications. The user of this machine shall have the sole responsibility for any malfunction which results from improper use or unauthorized modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than qualified persons approved by metabo or its representatives.
Metabo reserves the right to change specifications and design without prior notice and without incurring obligation of any kind.
Equipment referred to as available or optional may be at extra cost.
3 | Standard Accessories |
| |
| Spacing collars: | 1 pc. 25 mm, 1 pc. 16 mm, | Fence plates |
|
| 2 pcs. 10 mm, 2 pcs. 8 mm, | SUVA style safety cutter guard |
|
| 2 pcs. 5 mm | Tool set |
| Spindle nut: | M 30x2 | Instructions |
Fence
4 | Optional Accessories |
|
|
| Table Extension TF 100 | ||
| Sliding Carriage TF 100 | ||
| Moulding Tools | see separate catalogue | |
5 | Final Assembly |
|
|
|
|
|
|
|
|
|
|
Set table extension level with the table. Install cutter guard carrier on the fence. | Screw both stud bolts into the tapped | |||
|
| Use 4 each | bore holes of the table. | |
|
| - hexagon head screw M 6x25 |
| |
|
| - hex. nut M 6 |
| |
|
|
|
|
|
|
|
|
|
|
Place fence on table and screw starknobs onto stud bolts.
Slide hexagon bar into fence carrier and lock with starknob screw.
Install holddown shoe and spring on hexagon bar.
6 Installation
Important!
This spindle moulder model TF 100 M must be anchored to the floor for stability. A machine not anchored to the floor may fall over while in operation.
Use suitable means for anchoring, e.g. anchoring bolts or expansion anchors Ø 8 mm.
