09
Setting | What it does | Option(s) |
Adjusts the overall brightness.
c
Using other functions
Setting | What it does | Option(s) | |
ASP | Specifies the aspect ratio when input signals are output at the HDMI | THROUGH | |
output. Make your desired settings while checking each setting on |
| ||
(Aspect) |
| ||
your display (if the image doesn’t match your monitor type, cropping | NORMAL | ||
<g> | |||
or black bands appear). |
| ||
|
|
BRIGHT (Brightness) <d, e>
0
a ! If the video picture deteriorates when this settings is switched ON, switch it OFF. |
! When connected to a video device using the component video input, set this setting to ON and watch with the HDMI output. |
b ! When set to a resolution with which the TV (monitor) is not compatible, no picture is output. Also, in some cases no picture |
will be output due to copyright protection signals. In this case, change the setting. |
! When AUTO is selected, the resolution is selected automatically according to the capacity of the TV (monitor) connected by |
HDMI. When PURE is selected, the signals are output with the same resolution as when input (see About the video converter on |
d
(The image is only an example for checking the effect.)
Adjusts the contrast between light and dark.
| c |
CONTRAST | |
<d, e> | Default: 0 |
| 0 |
d
(The image is only an example for checking the effect.)
Adjusts the red/green balance.
c
HUE | |
<d, e> | Default: 0 |
| 0 |
d
(The image is only an example for checking the effect.)
Adjusts saturation from dull to bright.
c
| page 24). |
c | ! This setting is valid for HDMI output. |
| ! P.MOTION is disabled when PCINEMA is set to ON. |
| ! This setting have the effect only for pictures recorded in the interlaced scan format (480i/576i or 1080i signals). |
d | Adjustment is not possible unless V.ADJ (Advanced Video Adjust) is set to MEMORY. |
e | ! This setting is only displayed when the video signals below are being input: |
| — 480i, 576i, 480p, 576p, 720p, 1080i analog video signals |
| — 480i, 576i, 480p, 576p, 720p, 1080i, 1080p, 1080p24 HDMI video signals |
f | This adjustment is only possible when 480i signals are being input from the composite video jacks. |
g | ! If the image doesn’t match your monitor type, adjust the aspect ratio on the source component or on the monitor. |
| ! This setting is only displayed when 480i/p or 576i/p video signals are being input. |
CHROMA (Chroma Level) <d, e>
0
d
(The image is only an example for checking the effect.)
BLK SETUP | Sets the black level according to the video input signal. | 7.5 | |
(Black Setup) | Normally select 7.5. If the dark parts of the picture are all black with | 0 | |
<f> | this setting, select 0. | ||
|
66