Elo TouchSystems 1228L, 1225L manual Start Your Installation, Connecting the Touchmonitor Figure

7

Start Your Installation

￿Connecting the Touchmonitor (Figure 7.1)

To setup this touchmonitor, please refer to the following figure and proce- dures.

1.Be sure all equipment is off.

2.Connect the VGA signal cable from display input connector to the 15-pin connector of your host computer and tighten the screws.

3.Connect the female end of the touchscreen cable to the serial port on the back of your PC, and the male end of the cable to your touchmonitor.

4.Connect the DC power cord to the power connector; plug one end of the AC power cord into the power adapter, and then the other end into an electrical outlet.

5.Connect the Audio-In cable from audio input port of your touchmonitor to the Audio-out port of your computer. If you need to use earphone, connect your earphone cable to the earphone port of your display.

6.Turn on both your computer and touchmonitor.

￿Tilt

Grasp both sides of the monitor screen with your hands and adjust the tilt as desired.

￿Install Driver Software

Please refer to page 20 for driver software instructions.