VESA Mount on Your Touchmonitor
Figure 2.4 Stand and Display Separation
NOTE: The above drawing displays the VESA mounting interface after the removal of the mounting cover and base.
NOTE: You will need a 3mm Hex Wrench for the following steps.
•Remove the four screws in order to separate the stand from the monitor (see Figure 2.4).
•Rotate the monitor 180° (ensuring the monitor will not be upside down when mounted in the position shown).
•Reinstall the four screws.
•Route the cables through the cutout (if applicable) and mount the monitor to the wall using the template in Figure 2.
Elo Entuitive Touchmonitor User Guide
20
