Chapter 2 – Installation and Setup (Continued)
Touch Interface Connection
Note: Your interface cables may have been
1.Before connecting the cables to your touchmonitor and PC, be sure that the computer and the touchmonitor are turned off.
2.Connect the ferrite end of the video cable to the video connector on your PC. Connect the other end of the video cable to the touchmonitor. Secure the cable to your touchmonitor and PC by turning the screws on the connector.
3.Connect the female end of the serial
4.Power on your PC then your touchmonitor. After a brief pause the picture should appear.
5.Install the driver software using the procedure described in the documentation accompanying the driver disk.
Optimizing the LCD Display
To ensure the LCD display works well with your computer, configure the display mode of your graphic card to make it less than or equal to 1280 x 1024 resolution, and make sure the timing of the display mode is compatible with the LCD display. Refer to Appendix A for more information about resolution. Compatible video modes for your touchmonitor are listed in Appendix B.
VESA Mount on Your Touchmonitor (Desktops Only)
Your desktop touchmonitor comes with a VESA standard mounting holes for additional mounting options. Your touchmonitor conforms to the VESA Flat Panel Monitor Physical Mounting Interface (FPMPMI™) Standard, which defines a physical mounting interface for flat panel monitors, and corresponding standards for flat panel monitor mounting devices, such as wall and table arms.
The following companies provide VESA mounting devices compatible with your touchmonitor
Ergotron | Innovative Office Products | GCX |
www.ergotron.com | www.gcx.com |
Elo LCD Touchmonitor User Guide- 6
