REMOTE CONTROL INFORMATION
1. Power
Push this button to turn the unit into standby mode, push it again to turn off the unit.
2. Mute
Press this button to mute the sound, push again to cancel the mute function.
3. Test Tone
To balance speakers in Dolby Digital or Dolby Pro Logic mode.
4. Input Mode
To select input modes: ANA, OPT, and COAX when using digital in.
5. Display
Press this button to display the state of input source. And when listening to the FM broadcasting with RDS, press this button to show PS, PTY, RT and RT.
6.Input Selector buttons
7.Memory
Press it to store the broadcast station as a preset.
8. PTY Search
In FM state, press this button, the current program type appears on the display, using TUNING +/- to select the program type you desire.
9. Station +/-
Press these buttons to select a preset channel during the tuner mode.
10. Tuning buttons
-Tuning
-Band: Press this button to alternate between FM and AM.
-Auto/Manual: This button is used to select AUTO or MANUAL tuning for AM and FM stations. Press once to set to AUTO again for MANUAL.
-ST/Mono: Press this button to alternate between Stereo and Mono mode when listen to FM broadcast.
11. CH Select
Select channels by pushing this button, then use volume key to balance speakers.
12. Direct In
Press this button to select the 6.1 analogue input.
13. LFE Trim
Under the Pro Logic 5.1CH or DTS 5.1CH mode, press this button and adjust the volume to set the Low Frequency output level
14. Volume +/-
Press these buttons to decrease or increase the volume.
15. Bass
Press this button for Bass adjustment, then press +/- key to adjust the level.
16. +/-
These keys are used for SPK SETUP and DELAY TIME, Treble and Bass adjustment.
17. Treble
Press this button for Treble adjustment, then press +/- key to adjust the level.
18. Delay Time
Press this button to set the delay time for the Dolby digital/Dolby Pro Logic modes.
19. SPK Setup
Under PRO LOGIC II or Digital state, it can change the desired Speaker Setting shown on the display.
20. Dynamic
Press this button repeatedly to reach your desired compression dynamic range.
21. DTS/Dolby Digital
When playing 5.1CH source, and while you are enjoying Stereo, push this button to playback source in
DTS/DOLBY DIGITAL.
22. Surround Back
Push this button to turn on or off the surround back output.
23. Surround Mode
Selects surround modes: Theater, Hall, Passthru, Movie, Music, and Room.
24. Pro Logic IIx
When receiving Analog/digital PCM signal or 2CH Pro Logic, turn on this button then the playing is under analog 5.1CH state.
25. Stereo
With the unit in the STEREO mode, only front left and front right speakers and Woofer are working.
26. SUB On/Off
Push this button to turn on or off the subwoofer output.
14