Installation
INSTALLATION
Tabs 
Thermostat
1)Pull the thermostat off the base using tabs shown above.
2)Place base over wire hole in wall and mark mounting hole locations using base as a template. Drill mounting holes.
3)Fasten base snugly to wall using wall anchors and two mounting screws.
Leveling is for appearance only and will not affect thermostat operation.
4)Connect wires to terminal block on base.
Important: Wiring from equipment control should correspond with wiring to thermostat. (see Fig. 8)
5)Carefully line the thermostat up with the base and snap into place.
11
