BP7360 JULIANNE 9/19/07 11:15 AM Page 11
How to Wire Your Ceiling Fan
including ground, and that no bare wire is visible at the wire connectors, except for the ground wire.
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
!WARNING
Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.
CAUTION: To reduce the risk of electrical shock, disconnect the electrical supply circuit before installing the fan, light kit or receiver.
1. Position the supply wires to the left side of the outlet box (Figure 14); position the fan wires to the right side. Partially insert the remote control receiver (flat side up) until one end rests on the hanger ball as shown in Figure 14.
NOTE: Make all wiring connections using wire connectors (supplied). Make sure that all connections are tight,
2. Refer to Figures 14 and 15 and connect the receiver wires to the supply wires and the fan motor wires as follows:
a.Securely connect the green grounding wires from the hanger ball and the hanger bracket to the supply grounding conductor (this may be a bare wire or a wire with green insulation).
b.Securely connect the supply white (neutral) wire to the receiver white (AC IN N) wire.
c.Securely connect the supply black wire (hot) wire to the receiver black (AC IN
L)wire.
d.Securely connect the fan motor white wire to the receiver white (TO MOTOR
N)wire.
e.Securely connect the fan motor black wire to the receiver red (TO MOTOR L) wire.
f.Securely connect the fan motor blue wire to the receiver blue (FOR LIGHT) wire.
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
SUPPLY WHITE WIRE | ||
(NEUTRAL) |
| |
AC |
| |
I |
| |
N | N | |
SUPPLY BLACK | ||
| ||
WIRE (HOT) |
| |
GROUND WIRE |
| |
GREEN GROUND
WIRE FROM
HANGER BALL
ANTENNA
GREEN GROUND
WIRE FROM
HANGER BRACKET
Figure 14 STUD (2)
RECEIVER WHITE |
|
|
|
|
| |
WIRE | RECEIVER |
| ||||
|
| |||||
| BLACK WIRE | |||||
|
|
|
| RECEIVER RED WIRE | ||
|
|
|
|
|
| RECEIVER BLUE |
|
|
|
|
|
| WIRE |
|
|
|
|
| MOTOR | L |
AC IN L | MOTOR | N |
|
|
| |
| LIGHT |
|
|
| ||
|
| TO |
|
| ||
| TO |
| FOR |
|
| |
|
|
|
|
| ||
FAN |
|
|
|
|
| |
|
|
|
|
|
| |
BLACK |
|
|
|
|
|
|
WIRE |
|
|
|
|
|
|
FAN BLUE WIRE |
|
|
|
|
|
|
FAN WHITE WIRE | RECEIVER WHITE WIRE | |||||
| ||||||
11 | U.L. Model No.: CF220 |
