WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
| OUTLET | |
| BOX | |
TWO SCREWS |
| |
SUPPLIED WITH | HANGER | |
OUTLET BOX | ||
BRACKET | ||
| ||
Figure 8 | TAB | |
|
2.Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box. Be sure the groove in the ball is lined up with the tab on the hanger bracket (Figure 9).
WARNING
Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.
NOTE: CEILING COVER, |
|
SUPPLY WIRES AND | OUTLET |
FAN WIRES OMITTED | |
FOR CLARITY. | BOX |
| HANGER |
| BRACKET |
| HANGER BALL/ |
Figure 9 | DOWNROD |
ASSEMBLY |
WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and hanger bracket.
How To Wire Your Ceiling
Fan and Install the
Control
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it must be grounded for safe operation.
1.Connect the green grounding wire from the hanger ball, the green grounding wire from the hanger bracket to the grounding conductor of the supply (this may be a bare wire or wire with green colored insulation). Securely connect wires with wire connectors (supplied) (Figure 10).
BLACK | WHITE |
SUPPLY | SUPPLY |
(HOT) | (NEUTRAL) |
BLACK FAN WIRE | WHITE |
| |
| FAN WIRE |
SUPPLY GROUND |
|
WIRE | HANGER |
GREEN WIRE | BRACKET |
(GROUND) FROM |
|
HANGER BALL | THREADED |
GREEN WIRE (GROUND) | STUD (2) |
FROM HANGER BRACKET | LISTED WIRE |
| |
Figure 10 | CONNECTOR (3) |
|
2.Securely connect the fan motor white wire to the supply white (neutral) wire using wire connector supplied (Figure 10). Securely connect the fan motor black wire to the supply black (hot) wire using wire connector supplied (Figure 10). After connections have been made, turn leads upward and carefully push the leads into the outlet box, with the wires spread apart and the white and green leads on one side of the outlet box and the black leads on the other side of the outlet box.
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
6 | U.L. Model No.: CF765 |
