Emerson CF820ORB00, CF820PW00 Setting Operating Frequency of Wall Control Receiver Figure

Setting Operating

Frequency of Wall Control

and Receiver (Figure 24)

Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and

4)on the switches are factory-set in the ON (up) position. Change the switch settings as follows:

1.Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

2.In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

SW105 RECEIVER

CODE

SWITCH

Installation

of Wall Control

WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box.

The SW116 wall control transmits the command signals via radio waves to the SW105 receiver installed in the ceiling fan ceiling cover. The SW105 receiver is required for the SW116 wall control to function. Power for the SW116 wall control comes from the 12V battery, located in the wall control.

Replacement 12V batteries recommended are Duracell MN21, Eveready A23, and GP23A.

1.Install the 12V battery (supplied) into the wall control (Figure 25).

2.The SW116 wall control is supplied with a white, ivory or almond color cover. Choose the style that best suits your needs and snap the cover onto the wall control (Figure 25).

ON

1 2 3 4

RECEIVER SWITCH LEVERS

ON

1 2 3 4

WALL CONTROL LEVERS

	HIHI
U/L	MMED	LIGHT
	LOWLOW	REVREV
D/L	FAN OFF

WALL	12V BATTERY
CONTROL

HIHI
MEMDED	LIGHT
LOLWOW	RREVEV
FAN OFF

SW116 WALL

COVER	SW116 WALL
Figure 25	CONTROL

3.	Install the wall control onto the outlet box using the
	supplied screws (Figure 26).
4.	Install decorator wallplate (not included) using the

CONTROL

Figure 24

CODE SWITCH

two screws provided with the wall plate. Leave wall

control in “OFF” mode until fan installation is

completed (Figure 26).

DECORATIVE WALL PLATE	OUTLET BOX
(Purchased Separately)
		U/L
	HI
		LIGHT
	MED
		D/L
	LOW	REV
	FAN OFF

		SW116 WALL
	WALL PLATE	CONTROL
		WALL CONTROL
	SCREW (2)
Figure 26		SCREW (2)

11 U.L. Model No.: CF820