Emerson CF820ORB00 Install four 15-watt maximum candelabra light, If using the 6 downrod

NOTE: Take care not to scratch fan housing when installing blades.

WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balancing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

6.Loosely attach the flange assembly using two 1/4-20 x 16mm oval head screws (supplied) (Figure 3). Install the remaining four fan blades assemblies using the same procedure.

7.Gently snug all flange screws to the motor housing, working around the housing in a clockwise sequence. Failure to follow this procedure could result in fan wobble. This completes the blade installation.

8.Carefully turn the partially assembled fan/blade assembly upright and rest the assembly onto the styrofoam to continue the assembly.

9.Connect the fan motor housing yellow wire single-pin connector to the black wire single-pin connector from the uplight kit assembly; connect the fan motor housing white wire single-pin connector to the white wire single-pin connector from the uplight kit assembly (Figure 4). Be sure all wire connectors are fully engaged.

NOTE: Be sure wires and connectors are not pinched under the uplight kit assembly before securing the uplight kit assembly.

UPLIGHT KIT	#8-32 x 10mm FLAT
ASSEMBLY	HEAD SCREW (3)
	KEYHOLE SLOT

FAN MOTOR

HOUSING

UPPER GLASS

SHADE

15-WATT (max.)

CANDELABRA LIGHT BULB (4)

Figure 5

13.	Install four 15-watt (maximum) candelabra light
	bulbs (not supplied) in the uplight sockets
	(Figure 5).
14.	Obtain the hanger ball/downrod assembly and
	remove the hanger ball by loosening the
	setscrew in the hanger ball until the ball falls
	freely down the downrod (Figure 6). Remove the

UPLIGHT KIT ASSEMBLY WHITE WIRE SINGLE-PIN CONNECTOR

FAN MOTOR HOUSING WHITE WIRE SINGLE-PIN CONNECTOR

UPLIGHT KIT ASSEMBLY BLACK WIRE SINGLE-PIN CONNECTOR

pin from the downrod, then remove the hanger

ball. Retain the pin and hanger ball for

reinstallation in Step 25. Discard the 12” downrod

if using the 6” downrod.

PIN

HANGER

BALL

FAN MOTOR HOUSING

YELLOW WIRE

SINGLE-PIN CONNECTOR

Figure 4

CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the fan motor housing and the uplight kit assembly.

10.Unscrew and save one of the three #8-32 x 10mm flat head screws in the fan motor housing. (Figure 5).

11.Make sure all wires and single-pin connectors are inside the uplight kit assembly, then position the light kit assembly on the fan motor housing so that the holes line up.

12.Rotate the uplight kit assembly clockwise to engage the keyhole slots (Figure 5). Secure the light kit assembly to the fan motor housing by threading the previously removed screw into the remaining hole. Tighten the three screws at this time.

DOWNROD SETSCREW

Figure 6

NOTE: The longer downrod (12”) furnished with the ceiling fan provides the minimum recommended floor-to-fan blade clearance for a 9-foot ceiling. The 6” downrod (supplied) is to be used for shorter ceilings.

15.Separate, untwist and unkink the black, white and blue motor wires and the yellow uplight lead. Route these wires through the downrod.

16.Slide the downrod down the wires and seat the downrod in the motor coupling (Figure 7).

5 U.L. Model No.: CF820