Emerson CF820PW00, CF820ORB00 owner manual Electrical Requirements, Ceiling Fan Assembly Procedures

IMPORTANT: Your ceiling fan is supplied with an SW116 Fan/Light Wall Control (transmitter) and a remote control SW105 Receiver which mounts under the ceiling cover. This system allows you to regulate your ceiling fan speed, airflow direction, and light intensity. An optional Emerson Electric SR110 Remote Control may also be used.

IMPORTANT: Your ceiling fan will not function properly and may be damaged, if used with any wall dimmer switch or control other than the Emerson controls listed above.

Electrical Requirements

Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.

WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or Less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.

If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the existing light fixture.

WARNING

Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring. All wiring must be in accordance with national and local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

Ceiling Fan Assembly

Procedures

1.Place the flange onto the blade. Secure the flange to the blade using the four #10-32 x 8mm pan head screws and four #10 flat washers (supplied). Repeat for the four remaining blades. (Figure 1)

#10-32 x 8mm

PAN HEAD SCREW (4 Per Blade)

BLADE	#10 FLAT LOCKWASHER
	(4 Per Blade)

FLANGE

ASSEMBLY

Figure 1

2.Place the upper glass shade into the styrofoam for fan motor assembly.

3.Attach the fan motor assembly to the upper glass shade using the four #10-32 x 10mm pan head screws and lockwashers (supplied) (Figure 2).

LOCKWASHER (4)	#10-32 x 10mm
	PAN HEAD SCREW (4)

FAN MOTOR

ASSEMBLY

UPPER GLASS SHADE

STYROFOAM

Figure 2

WARNING

To avoid possible fire or shock, follow all wiring instructions carefully. Any electrical work not described in these instructions should be done or approved by a licensed electrician.

Preliminary Procedures

IMPORTANT: Before assembling your ceiling fan, refer to sections “Setting Operating Frequency of Wall Control and Receiver” and “Installation of Wall Control”, Page 11. These sections instruct you how to:

a.Set the operating frequency of the fan/light wall control and the remote control receiver.

b.Install the fan/light wall control in the wall box.

You will then be ready to proceed with the assembly and installation of your ceiling fan.

4.Carefully turn the partially assembled fan motor upside down and place into the styrofoam for blade assembly installation.

5.Rotate the switch housing plate to align the holes in the blade flange assembly with the holes in the motor housing (Figure 3).

1/4-20 x 16mm OVAL	BLADE FLANGE
HEAD SCREW (2 per	ASSEMBLY
flange assembly)
SWITCH
HOUSING PLATE

Figure 3

4 U.L. Model No.: CF820