Unpacking Instructions

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One stepladder One wire stripper

One Phillips head screwdriver

Four 15-watt (max.) candelabra base bulbs (not supplied) Three 40-watt (max.) candelabra base bulbs (not supplied)

MATERIALS

Wiring outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the wire size, to right:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

WARNING

If you feel you do not have enough wiring knowledge or experience, have your fan installed by a licensed electrician.

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

7.One hairpin clip

8.One clevis pin

9.Twenty-one #10-32 x 8mm pan head screws

10.Twenty-one #10 flat washers

11.Eleven 1/4-20 x 16mm oval head screws

12.Four #8-32 x 10mm flat head screws

13.Five #10-32 x 10mm flat head screws and lockwashers

14.One balancing kit

NOTE: Place the parts from the loose parts bags in small containers to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

1. Open styrofoam unit containing fan. Remove upper

and center sections of styrofoam unit. Remove parts