SW105 RECEIVER
BLACK SUPPLY
WIRE
WHITE RECEIVER WIRE
BLACK RECEIVER WIRE | WHITE SUPPLY WIRE |
BLACK/WHITE
RECEIVER WIRE BLUE RECEIVER WIRE
BLUE FAN WIRE
WHITE FAN WIRE
YELLOW RECEIVER WIRE
BLACK FAN WIRE
YELLOW FAN WIRE
DOWNROD
Figure 16
WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
4.After connections have been made, separate the white and green wires from the black, blue and orange wires.
5.Carefully turn the wires upward and insert them up through the open side of the hanger bracket and into the outlet box. Push the green equipment/earth ground and white grounded neutral wires into one side of the outlet box; push the black, blue and yellow ungrounded wires into the other side of the outlet box.
OUTLET BOX
HANGER
BRACKET
RECEIVER | |
STUDS (2) |
CEILING
COVER
Figure 17
6.Screw the two
9
7.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 18).
8.Secure the ceiling cover in place by installing two lockwashers and two knurled knobs (supplied) (Figure 18). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod.
9.Your ceiling fan in now installed and wired.Proceed to Switch Housing/Downlight Kit Installation to complete your fan installation.
OUTLET
BOX
| HANGER |
| BRACKET |
CEILING COVER | |
STUD (2) | |
HANGER BALL/ | LOCKWASHER (2) |
DOWNROD ASSEMBLY | KNURLED KNOB (2) |
Figure 18
WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
Switch Housing Installation
NOTE: If no downlight is desired, continue with switch housing installation.
NOTE: Do not install the downlight fitter assembly.
1.Attach the
2.Place the switch housing onto the switch housing plate aligning the three holes. Secure the switch housing using three screws (supplied).
3.Screw the switch housing center plug into place.
SWITCH HOUSING
PLATE
| FAN ASSEMBLY |
| |
| SWITCH HOUSING |
| |
SWITCH HOUSING |
|
SCREW (3) | SWITCH |
| HOUSING |
Figure 19
4.Your ceiling fan is now installed ready to be controlled by your remove control system.